Videos from our workshop

Over the years we have completed a plethora of different projects and here we've posted some of the more interesting ones.

Recycled Vintage European Oak Vanity

The hand finishing of a 4.5 * 1.2 meter Tallowood Dining Table

Assembly test run of a 2.2m round reclaimed teak table

Before gluing the 70mm thick outer segments in place it's wise to do an alignment test run, because once you start gluing there's no going back.  Each sliver in this table is cut at 3.75 degrees (there are 48 of them, and another 48 in the lazy susan), so the opportunity for cumulative error is high.  Even the 16 outer segments are cut at 11.25 degrees, so it's easy to mess these up too.

Rounding off of 2.2m table

The table was actually built as a hexadecagon, each segment partially rounded off using a bandsaw (prior to gluing in place) and then finely rounded into a true circle using a router jig with a 75mm long straight 1/2 in router bit.  Word of advice - good ear protection is essential as long router bits are LOUD.